Section 2. Installing the PX-716UF External USB/FireWire Drive
14
PX-716UF Installation and Users Manual
•
IEEE 1394 6-pin connector
: Connect an IEEE 1394 (FireWire)
cable with a 6-pin connector here.
NOTE
: The PX-716UF does not get its power from the IEEE 1394
bus or the USB bus. It must be connected to the AC adapter.
CAUTION
: Use only the IEEE 1394 (FireWire) cable shipped with
your PX-716UF.
•
Interface switch
: Switch the PX-716UF drive to operate with a
different interface (USB, IEEE 1394). This allows you to connect the
drive to either interface, depending on the requirements of your
computer. If you change interfaces with this switch, you must also
cycle the PX-716UF power. (That is, turn the rear-panel power
switch off, then on again.)
•
USB 2.0 connector
: Connect the USB cable here. You can use a
USB 2.0 or USB 1.1 interface.
CAUTION
: Use only the USB cable shipped with your PX-716UF.
•
DC 12V power connector
: Connect the AC adapter here.
CAUTION
: Use only the AC adapter shipped with your PX-716UF.
•
Power switch
: Press this switch to turn the power on or off. Press
the “0” down to turn power off. Press the “1” down to turn power on.