Plextor PTR 2, Руководство пользователя

Страница: 54 / 235

55
•
Press the Record key again at any time and the recording will be
paused. The LED in the Record key starts to flash again.
•
Restart recording by pressing the Record key again. The LED
becomes a solid red light.
•
To stop recording, press the Play/Stop key.
NOTE: Each time you start recording in Normal mode, a new section is
automatically created at the end of the existing recording. You do not
need to navigate to the end before recording new material.
NOTE: At any time in recording stand by, recording pause or during
recording, you can switch off and on the recording monitor by pressing
the Bookmark key. This allows you to listen to how the recording sounds
whilst recording. When recording from the built in microphone or an
external microphone, you must be using headphones for this feature to
work.
NOTE: In recording pause or during recording, you can turn on the level
monitor to get an indication of whether the recording level is "Low",
"Good" or "High". Turn on the level monitor by pressing the Information
key. Press the Information key again to turn it off.
8.4. Editing a DAISY recording.
Some of the editing features can be used during the recording process or
afterwards. The most common of these are the insertion of heading and
page codes.
To insert a heading during recording, press the Heading key once. To
insert a page code during recording, press the Page key once.
In recording pause, press the Heading key or the Page key to insert a
heading or page when recording recommences. In recording pause, if you
have previously pressed the Heading or Page key, press the Heading or
Page key again to cancel the heading or page that you had just created.
After completing the recording, to insert a heading or page, go to the
location where you want to insert the heading or page and then press the
Heading or Page twice respectively. PLEXTALK will then ask you to
confirm the position. Use the Number 4 or 6 key to adjust the position
back or forward by 0.1 second increments. Press the Enter key at the
location where you want.