To remove your computer’s cover, follow the directions provided by your computer’s
manufacturer. Typically, this involves loosening or removing several screws on the
back panel of your computer and sliding off your computer’s cover.
Carefully remove the SCSI interface board from its packaging. Select a vacant slot in
your computer where you will install the board (refer to the manual packaged with
your interface board for instructions as to which slot in your system to use). If you are
installing an internal drive, try to pick a slot that is closest to where the drive will be installed.
Remove the cover plate for this slot from the back panel of your computer. Keep the
screw from the cover plate nearby, as you will need it in a moment. Save the cover
plate in case you need it at a later date.
Plug the SCSI interface board into the slot you have selected. Rock the board from
end to end to ensure that it seats firmly in the slot. Don’t force it. If you cannot push
the board down completely into the slot, remove the board and try again.
Expansion Slot Cover
Rear Panel
CHAPTER 8 ---- Hardware Installation
5.75" x 8.25" PLEX WRITER MANUAL
Plextor Manual,
Carla Williams
1/2/98
PX-R412CS OPERATION MANUAL
23
