Plextor 12-20D, Руководство пользователя

Страница: 10 / 24

other disks you have), you can try using the files provided by Windows 95, but we
cannot guarantee you will get SCAM support.
Reboot Your Computer
Reboot your machine by selecting ‘‘SHUT DOWN’’ from the START Button. In the
shut down dialog box select ‘‘Restart the Computer’’ and select ‘‘YES.’’ This will reboot
your computer with the new configuration. As your system goes through all its self
checks, you might find it interesting to watch the display and note the SCSI ID that
has been assigned to your CD-ROM drive. Your drive came from the factory physically
set to ID #3. It is possible (especially if you have other SCSI devices) that once you
reboot your computer, the configuration process will reassign the drive to some other
SCSI ID number. If so, you have just seen visual proof of Plextor’s SCAM capabilities.
Get out your favorite or most useful CD and enjoy.
Troubleshooting
If you followed the previous instructions, you should be up and running without any
problems. If things are not working correctly, there are four likely problems.
•
First, you might have overlooked our instructions to use the Plextor
Manager disk to get the necessary driver support for your SCSI
controller. If you used the Windows 95 disk or CD, the configuration
process may have copied the wrong (i.e., non-SCAM capable) driver
support. Then, if some other SCSI device attached to your SCSI
controller is physically set to the same ID as your CD-ROM drive, a
conflict will occur. To solve this problem, insert the Plextor Manager
disk or use Windows Explorer or the following DOS command to copy
the correct file to the applicable Windows 95 subdirectory:
copy A:\*.MPD C:\windows\system\iosubsys
Reboot again and everything should work fine.
•
The second likely cause is that your motherboard may not have a Plug
and Play capable BIOS and your Plug and Play SCSI controller is not
of the PCI variety. You will need to turn off your computer and disable
the Plug and Play capabilities on your SCSI controller. Review the
controller’s documentation (check the Quick Start Guide or similar
document first) to determine the location of the disable switch. After
disabling, review the ‘‘Install Hardware’’ portion of the Non-Plug and
Play Installation section of this manual. Make sure termination is set
properly on your controller and all devices attached to it. Restart your
computer.
Appendix ---- Windows 95 Drivers
68
12/20PLEX OPERATION MANUAL