Neurotechnology Research Systems
Optogenetic Controller
- 8 -
5
Installation
Read the entire installation section before proceeding with the installation. Follow the installation
steps in the order that they are presented. Install the software first, followed by the hardware. Do
not connect the controller to an implant until you have read the entire manual.
5.1
Software Installation
Read the entire Software Installation section before proceeding with any of the steps.
5.1.1
Browse to the \Optogenetic Contrller\Radient_x64 or \Radient_x86 folder on the USB flash
drive depending on if you have a 64 or 32 bit operating system
5.1.2
Right-click the file Radientx86v1Setup.exe or Radientx64v1Setup.exe and select Run as
Administrator to begin the installation process. On some computers, you will get a warning:
5.1.3
Click Yes or Run to continue. The welcome screen appears:
If the software is already installed, then the welcome screen gives you the option to repair
(re-install) or remove the software as shown on the right above. If the software is not
already installed, then the welcome screen shown above on the left appears.
Click Next to continue.