TC-SPD2000
DT Istr (TC-SPD2000) 05/18 – Rev 0_05/2018
12/16
12.
This equipment should not be operating without
monitoring.
13.
The appliance must be placed at a minimum height of
1.8 meters from the ground.
14.
CAUTION - Some parts of this product can become
very hot and cause burns. Particular attention has to be given
where children and vulnerable people are present.
GENERAL WARNINGS
1.
Remove all the packaging material and make sure that the appliance is in good condition. If you have any
doubt, do not use the appliance and contact our After-Sales Service. Keep the packaging material (staples,
nylon bags, etc.) out of the reach of children. Before turning the appliance on, check that the voltage and
frequency of the power socket are compatible with those indicated in the product technical plate.
2.
This appliance must be connected to an approved mains socket that complies with the safety regulations on
electrical systems for civil purposes. The electrical system must be specific for the appliance rated voltage
and must be equipped with an earth cable.
3.
The appliance must be used only for its intended use, that is, as a heater for domestic heating. Any use
other than its intended purpose shall be deemed to be improper and hazardous.
4.
The manufacturer shall not be held responsible for damages derived from misuse of this appliance, do not
assuming any responsibility in case of incorrect use that will decline any warranty.
5.
In order to have a good air aspiration and to avoid damaging of the product, maintain the air inlet and outlet
free from objects.
6.
The appliance has dangerous components that must be kept out of the reach of children.
7.
Never connect the power cord to extensions or triple plugs. Do not pull or damage the power cord. Before
any maintenance operations, disconnect the plug from the mains socket.
8.
The power cord must never be in contact with the hot surfaces of the appliance.
9.
Do not lay the power cord under a carpet. Do not cover the power cord with a cover or similar elements.
Pay attention not to place the power cable where it is likely to get into people's way.
10.
If the appliance does not work properly, immediately turn it off and disconnect it from the mains socket.
For repairs, contact a technical support center authorized by the manufacturer, and require that original
spare parts be used. Using parts that do not conform to the product may seriously compromise its correct
operation.
11.
In order to unplug the appliance, select button (1) and disconnect the plug from the power socket.
INSTRUCTIONS FOR MANUAL USE
Connect the appliance to an electrical outlet and press switch 0/I on the right side of the
apparatus, the device will turn on in standby mode showing "S-" on the display.
To start the ventilation press the power button , the display will show "- -"
Select using the button the desired power heat
( = 1000W, = 2000W),
While the fan heater is operating, with the button you can set the operating time, each
time you press the button the duration will increase of 1 h (from a minimum of
1h up to a max of 12 h).
While the fan heater is in standby mode, using the button you can set the timer to
automatically switch on from 1 to 12 h, the display will show the remaining hours before it
turn on (the appliance after 12 hours of continuous work will automatically enter in standby
mode).
ALL OF THE LIGHTS ON THE DISPLAY INDICATE THE OPERATION MODE
CURRENTLY IN USE.
INSTRUCTIONS FOR THE USE OF THE REMOTE CONTROL
To turn on the fan press the key .
