Plebani Daitona, Руководство пользователя

Страница: 28 / 56

Put car-seat on the selected seat of the car (Fig. 28) keeping it slightly detached from the
backrest; we always recommend you to place it on back seat opposite to driver. For an
easier installation, fully unroll belts of car, let them slide in front of car-seat, then insert
them into one of belt slot (P) (Fig. 29), slide them behind the backrest of car-seat, let them
out of the other slot and then fasten them to the buckle (Fig. 30). Check that the horizontal
belt goes under the armrest of car-seat and the diagonal belt is free above (Fig. 31). Push
car-seat against the backrest of the car, pass the diagonal belt under the headrest into the
groove (Fig. 32), pull and tighten belts of car.
IMPORTANT: ALWAYS MAKE SURE THAT CAR'S BELTS ARE NOT ROLLED AND/OR
TWISTED!
USE FOR GROUP 2 e 3 (from 15 to 36 Kg)
WARNING: When using "DAITONA" in its group 2 and 3 versions, that is for children from
15 to 36 kg, it must be fixed only on seats equipped with 3-point safety belts with diagonal
and lap belts, static or with winders, on front or rear passenger seats. It can not be
installed on seats with only the diagonal or two anchor points belt (Fig. 2).
It can NOT be placed on OPPOSITE-facing or SIDE-facing direction seats (Fig. 3).
In questa versione, il bambino utilizzerà le cinture dell'automobile (Fig. 33) e non più
quelle del seggiolino, bloccando le cinture con il tendi-cinture (M) (Fig. 34). Bisogna quindi
sbloccare il seggiolino dalla versione “Gruppo 1” (se precedentemente installata) e
rimuove le cinture del seggiolino come nelle operazioni sopra descritte (Fig. da 16 a 19).
In this version, the child will use the belts of car (Fig. 33) and not the car-seat belts,
locking belts with seat-belt lock (M) (Fig. 34). Therefore it's necessary to unlock car-seat
from "Group 1" version (if previously installed) and remove car-seat belts as in the
operations described above (Fig. 16 to 19).
Headrest (A) can be adjusted in different positions (Fig. 35) to adapt to the baby's growth.
Lift the adjustment lever (N) behind the headrest (Fig. 36) and raise or lower it according
to the height of the child. Check that the baby's head is well protected and inside the
headrest, otherwise adjust it appropriately.
Let sit your child into car-seat (Fig. 37) and fasten diagonal belt in seat-belt locker (Fig.
38). First, enter it from one side (Fig. 39) then to the other side (Fig. 40) and tension it by
adjusting the length with the bracket (R) and then tighten well the belts of the car.
ALWAYS MAKE SURE THAT CAR'S BELTS ARE NOT ROLLED OR TWISTED, BUT
WELL TIGHTED