Platinum PRO Treadmill 3.0, Руководство пользователя

Страница: 45 / 56

English
33
General Cleaning
Dirt, dust, and pet hair can block air inlets and
accumulate on the running belt. On a monthly
basis: vacuum underneath your treadmill to
prevent buildup. Twice a year, you should
remove the black motor hood and vacuum
out dirt that may accumulate.
UNPLUG POWER CORD BEFORE THIS TASK.
Belt adjustments
(FIG. E-60)
Adjustment must be made from the rear
roller. The adjustment bolts are located at
the end of the step rails in the end caps.
- Tighten the rear roller bolts (clockwise)
only enough to prevent slippage at the
front roller. Turn both running belt
tension adjustment bolts in increments of
1/4 turn each and inspect for proper
tension by walking on the belt at a low
speed, making sure the belt does not
slip. Keep tensioning the bolts until the
belt stops slipping.
- If you feel the belt is tight enough, but it
still slips, the problem may be a loose
Motor drive belt under the front cover.
- Do Not Over-tighten
Over tightening will cause belt
damage and premature bearing
failure.
Running belt tracking adjustment
The performance of your treadmill is
dependent on the frame running on a
reasonably level surface. If the frame is
not level, the front and back roller cannot
run parallel, and constant belt adjustment
may be necessary.
The treadmill is designed to keep the running
belt reasonably centered while in use. It is
normal for some belts to drift near one side
while the belt is running with no one on it.
After a few minutes of use, the running belt should
have a tendency to center itself. If, during use, the
belt continues to move toward one side, adjustments
are necessary.
Exception: During rehabilitation where the user is
using one leg much stronger than the other, it might
happen that the running belt drifts to one side. In
these cases you should not adjust unless the running
belt does not centre itself during normal condition
usage.
To set running belt tracking
(FIG. E-59)
A 10 mm Allen wrench is provided to adjust the rear
roller. Make tracking adjustments from the left side
only. Set belt speed at approximately 3 to 5 kph.
Remember, a small adjustment can make a dramatic
difference!
Turn the bolt clockwise to move the belt to the right.
Counterclockwise to move to the left. Turn the bolt
only a 1/4 turn and wait a few minutes for the belt to
adjust itself. Continue to make 1/4 rotation turns until
the belt stabilizes in the center of the running deck.