Platinum CHARIOT S4, Руководство пользователя

Страница: 18 / 50

1. Ref to your tent map and understand which poles are needed for (Awning One) setup
2. Layout poles required on the ground in preparation. This is much easier than looking for poles as you go.
3. Lay the awning on the ground along the side of the trailer that you are
attaching it to. Awning should be attached from right to left via a zipper on the main tent.
4. Stand on a small ladder or chair, hold the awning up to the left hand side of the main tent and zip it on from
underneath, you will find that the zipper will flow a lot easier this way. Two people is always best when putting
the awning and poles up.
5. Starting from right hand side of the main tent, insert your first cross bar #8 through the nuts on the main tent
frame on one end, then insert #9 crossbar and #10 pole on the corner of the awning one.
6. Then repeat this process as per the tent map. (REFER TO AWNING ONE DIAGRAM)
7. When you get to pole #16, place it through the pocket near the bed, with the flat end sitting on the floor next
to bed, and extend - Then insert the #7 pole and finish off the awning.
8. Use the provided guide ropes and pegs to secure the awning.
*Tip Build the awning low, then raise the end poles up at the end.
AWNING ONE SETUP
Awning Spreader Bars
Spreader Bars are useful in windy, wet weather and give more strength to the awing frame work.
If you ever find that you are getting pooling water, grab an extra no.4 pole and attach it between the framework,
down the centre line. We recommend using a couple even in great weather and it just firms up the whole
camper. (There are extra No.4 poles included in your kit) Use as needed.
Awning Tie Down Ropes and Pegs
The awning is somewhat self standing, and while it will stay there, it is recommended to secure the awning
further using tent ropes and pegs. This will help secure the awning in high winds and keep you and your family
dry!
Awning Walls and Floor
You may decide to attach walls and floor to your Awning during this setup. These room walls attach to the
awning roof via zipper. Also there is wall ends supplied, these walls attach to each end of the awning via velcro
stripping to each end of awning one and two. Also supplied is floors for each rooms, these floors attach to the
under side of all wall via velcro stripping at the base of each wall. (REF TO TENT DIAGRAM)
PAGE 17 C H A R I O T S 4 | O W N E R ’ S M A N U A L