SOLAR LIGHTS
CARE AND USE INSTRUCTIONS
2
STEP 1
STEP 2
STEP 3
STEP 4
Do not over-tighten
Remove protective
film from solar
panels.
Turn the switch
underneath the remote
solar panel to “ON”
position.
IMPORTANT NOTES:
Remove protective film from solar panels. To allow each battery to reach full
capacity, pull out the plastic tab and place in full sunlight for the first 12 hours.
Failure to do so can shorten the life of the battery or operation of the light.
To protect the glass from damage, do not use force during assembly. Keep the
glass in the packaging until you need to install it.
GROUND STAKES
Pre-drill a hole into the ground using a screwdriver. Do not make the hole larger than
the ground stake. Insert assembled solar light into the pre-made hole. Do NOT use a
hammer on the ground stakes as you could damage the item.
BATTERY INFORMATION
INSTALLATION / REPLACEMENT INSTRUCTIONS
1. Slide the power switch to the “OFF” position
.
2. Access the battery compartment by unscrewing the remote solar panel using a
Phillips head screwdriver.
3. Remove old battery and replace with new AA NiMh 450mAh rechargeable
battery. Do not use a smaller mAh battery as it will affect performance. Larger
mAh batteries are acceptable.
4. Ensure you have positioned the batteries with the correct polarity (+) and (-).
5. Replace battery cover and re-insert the screws on the remote solar panel.
