16 Channel Digital Video Recorder User s Manual
29
the screen, when is tip blinking the backup of the picture is done, you can plug the USB device
out and see the picture on a computer.
If you select MOVIE
for the backup mode in the Backup Set menu, push the USB button in shift
mode, it begin to backup the main out video to the USB device from the moment, push USB
button again to select the end of the backup video, there will be a A
blinking on the screen, This
may take a little time, and make sure the USB device has enough free space, if blinking stops, the
backup is ok, you can see the video on a computer with net viewer software.
6.12 USB Update
Create a folder named firmware
in the USB root directory, copy the update files to the folder,
Plug in the USB device, go to the menu of Backup set, check that if the USB device was detected
or not, go to the Firmware Update menu and select USB method, move to Update Start and press
enter button, update will start, if you see picture below, update is ok.
Then reboot the DVR
NOTE: do not shut down the DVR when the DVR is updating, it may cause fatal problem.
6.13 Zoom
In shift mode, press zoom button or press the zoom button on the remote controller, the DVR will
be in zoom mode, which is illustrated as below.
Press upward, downward, leftward or rightward to move the zoom area, then push enter button to
zoom, press zoom button again to cancel zoom operation.
6.14 FREEZE
Press the Freeze button on the remote controller or keyboard, on the full screen mode Press
the Freeze button to pause a screen; on the other modes, press the Freeze button to see the
Freeze menu. Here, select a channel number to freeze.
6.15 PTZ OPERATION
This DVR can control speed domes, which are connected to the DVR.
To control the speed dome, make sure all the lines are correctly connected, first you must set the
right protocol, baud rates, and speed dome s address for each speed dome, please refer to
protocol set.
PTZ can only be operated by remote controller, press the PTZ button on the remote controller,
PTZ
will be display on the screen, then select 1 to 16 to choose PTZ channel, the channel
number will be displayed after PTZ . You can press upward, downward, leftward, rightward button
to move the speed dome, and press the button again or press enter to stop. If you press the IRIS
button, the character IRIS
will appear on the screen, please refer to the picture below, then you
can press the + and -
button to change the IRIS, the same to control the focus, zoom, and
speed, also press enter button to stop.
Press the PTZ button one more time to exit from PTZ control.
