Installation | Assembly Instructions
29
Cooling Pad | Installation and Operation Guide Rev B | Doc P/N: 080205039E
Gluing PVC Pipes
To ensure a proper leak-proof connection between a pipe and fitting, first cut
the pipe to length and sand off the saw burrs. Then do the following:
6.
Hold the pipe and fitting
together for 15 seconds to
ensure a proper seal
1.
Make marks on the pipe and fitting to
ensure correct orientation during insertion
2.
Wipe the inside of the fitting
and outside of the pipe using PVC
primer, and let dry for 10 seconds
3.
Apply an even layer of PVC cement
to both of the parts being attached
NOTE:
To ensure excess PVC cement is not
pushed into the pipe, do not apply too
much cement to the inside of the part
NOTE:
Steps 4-6 should be done quickly,
before the cement dries
4.
Insert the pipe into the
fitting about a quarter turn
from its final orientation
5.
Twist the fitting to its
correct orientation while
pushing it onto the pipe
NOTE:
Make sure mark is long
enough to still be visible
after fitting is assembled
WWW
