PlasmaMade Airfilter, Инструкция по установке и эксплуатации

Страница: 11 / 48

10
8. Installation instructions
The
PlasmaMade Airfilter
may be used on almost all existing and new-installation
extractor hood units. The extractor hood must fulfil the following points:
• Extractor hood must be suitable for recirculation (the duct must feature openings
through which the filtered air can be returned back into the room). We do not
recommend these openings to be directed at the wall or ceiling. Provide a gap of
at least 500 mm in between.
• Set the electronic control of the hood to recirculation mode, if the control is not
available here than using the hood at position 1 or 2. If the engine capacity is
higher than 600 m3
• Top of motor housing to top
of duct must be at least 400 mm.
• We recommend respecting a minimum distance from hob to bottom of extractor
unit (due to the heat production from the hob) of:
Induction/ceramic > 65 cm
Gas hob > 70 cm
Gas wok, 3.2 - > 6 kW > 75 cm
• A mains socket within a suitable distance (220 V, no earth needed).
• We recommend you to treat the steel parts and/or components in the inner side
of the hood against corrosion by moisture. This is often the case with lower
quality hoods that aren’t built with galvanized or stainless steel.
Note: If the extractor unit is mounted at a smaller distance above the hob, the
PlasmaMade Airfilter ’ s guarantee is invalidated.