Operating elements
Plasma Screenland
04/07
9
En
Operating elements
Controls
Front of the unit
1
2
3
4
5
SOURCE
STANDBY
1
POWER
Power switch: Switch the TV on and off
2
Indicator light showing TV switched on (green)
Standby indicator (red)
Remote control receiver
3
SOURCE
Select the input signal by pressing the 4
∆
/
∇
buttons
TV-BOX, YCbCr (DVD component signal), VGA or
DVI (PC socket)
4
∆
/
∇
for SOURCE selection
5
Standby
Switches off the unit temporarily (ready for operation);
the red standby indicator 2 lights up. To switch the unit
back on, press the button again or press the POWER 12
button on the remote control, indicator lights up green.
Setting the remote control
If the equipment is operated with the remote control, observe
the following:
The RC 902 remote control can control up to five different
devices:
•
TV,
•
DVR,
•
SAT,
•
DVD and so-called
•
PC mode; To operate the plasma display, press the Mode
37 button until the TV and DVD LEDs light up simulta-
neously
Note:
The blue button lettering on the remote control
usually comes as standard!
PC
P
C
To operate the Scinema_Box II, press the Mode 37 button un-
til the TV LED lights up.
Notes on the remote control
In general:
•
Point the remote control (transmitter) at remote control
receiver 2 on the unit.
•
An optical connection must be established between the
transmitter and the receiver.
•
If the range of the remote control decreases, replace the
batteries.
