Planeta Premium Pro-E, Руководство по эксплуатации

Страница: 6 / 20

Chain Hoist PREMIUM PRO-E
6
3 SPECIAL SAFETY
ADVICES
4 INSTALLATION
INSTRUCTIONS BEFORE
OPERATION
4.1 Before first use
4.2 Installation and testing prior to
each use
Certain jobs and operations are forbidden when using a hoist, because they
can possibly cause danger for life and health and damagethe hoist, as for
example:
– Read the user manual before operation.
– Never drive the hoist with mains current powered devices
– Never overload the hoist above it WLL
– Never lift a load above persons
– Never pull the lifting chain over sharp corners
– Never work with a damaged hoist
– Never lift or transport persons with this hoist
– Never throw the hoist
– Never use the lifting chain for rigging
– Never work up to the end of chain
– Never attach the load on the tip of the hook
– Never work with a twisted or broken chain
– Never work without a safety latch
– Never remove the warning notice
– Never use the lifting chain as chain sling
– Never let a lifted load häng unattended
– Never pull loads in a angle
– Never break free stucked loads with this chain hoist
– Chain hoists which are added to a travelling trolley or are supplierd with it
are subject to the actual German safety standards for cranes. Please follow
the country specific standards and regulations.
– Never use the hoist below -20 degrees Celsius or above + 60 degrees Cel -
sius.
– Hang hoist with the top hook into the load carrying system and turn it once.
– The load chain must hang free and be without kinks or twists.
– Drive the hoist for 5-10 seconds in liftig and lowering direction.
– Inspection of load brake, lift the load a bit and stop operation. When the load
sustains, go on lifting. When lowering, the load shall not slide after operation
has stopped.
– If everything is performed properly, operation can be started.
– Important for devices of multiple lines: Lower block shall not be snapped
through the chain loop. This can be recognised by a twisted chain. Each
second chain link of one strand is not steadily in line. If the welded seams of
the chain links are not in same direction the lower block must be struck back
through the chain loop.
– The last chain link must be fastened on the hoist body.
NO WAY