23
4. Troubleshooting
This chapter contains information to help you solve issues. If
the Media Converter is not functioning properly, make sure
the Media Converter is set up according to instructions in this
manual.
The per port LED is not lit
Solution:
Check the cable connection of the Media Converter.
Performance is bad
Solution:
Check the speed duplex mode of the partner device. The Media
Converter usually runs in auto-negotiation mode. If the partner
is set to half duplex, the performance will be poor.
Per port LED is lit, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full duplex.
Some devices use a physical or software switch to change
duplex modes. Auto-negotiation may not recognize this type of
full-duplex setting.
Why the Media Converter doesn’t connect to the network
Solution:
Check per port LED on the Media Converter. Make sure the
cable is installed properly. Make sure the cable is the right type.
Turn off the power. After a while, turn on the power again.
