Parameters
Description
Enable Port Forwarding
Enable Port Forwarding.
Private IP
This is the private IP of the server in LAN.
Note:
You need to give your LAN PC clients a fixed/static IP address for Port
Forwarding to work properly.
Type
This is the protocol type to be forwarded. You can choose to forward “TCP”
or “UDP” packets only or select “both” to forward both “TCP” and “UDP”
packets.
Port Range
The range of ports to be forward to the private IP.
Comment
The description of this setting.
Add
Fill in the "Private IP", “Type”, “Port Range” and "Comment" of the setting to
be added and then click "Add". Then this Port Forwarding setting will be
added into the "Current Port Forwarding Table" below. If you find any typo
before adding it and want to retype again, just click "Clear" and the fields will
be cleared.
Reset
Click “Reset” will clear your current settings to allows you to enter again.
Current Port Forwarding Table
Delete Selected
If you want to remove some MAC address from the “Current Access Control
List”, select the MAC addresses you want to remove in the table and then
click “Delete Selected”.
Delete All
If you want remove all MAC addresses from the table, just click this button.
Reset
Click “Reset” will clear your current selections.
After configuration complete, please click “Apply”
button to save the configuration. Then you will see a
screen to prompt you the settings are saving successfully. You may press “Continue” for configure other
54
