25
1.
Act as Master test station:
You should input the destination slave test station address before press [
Start
] button. The
slave address can be found from the slave test station’s screen. The “Master Test Station”
window will be displayed after pressing [
Start
] button.
Fig 4.9 Act as Master test station
The “Master Test Station” window contains the following status/ statistical information during
the Link Quality Test session:
¨
Slave / Test Address:
The physical address of the destination slave test station. (Self
physical address will be displayed while performing Access Point loopback test.)
¨
Packet Sent:
Total test packets have been sent.
¨
Packet Received:
Total responding packets have been received.
¨
Elapsed Time:
Total testing time.
¨
Signal level:
The signal level when receiving last responding packet. The signal level is
calculated as the percentage of its signal level measurement relative to the full signal level.
