Hardware Installation
Before you proceed with the installation, it is necessary that you have enough
information about WAP-6200.
1. Locate an optimum location and use the provided Mounting kit to tie the WAP-
6200 to a pole.
Note
For secured reason, while install the CPE AP, please be aware for
the electric wires around, and tighten the pole.
Without tighten the CPE AP, the pole and the installed site is with
electric wire around, there could be danger of being hurt by falling
or lethal injury.
2. Strongly suggest using SFTP cable (PLANET offers 25-meter SFTP cable, please
contact with local dealer for more information.) for waterproof and avoiding
thunder stroke, connect the RJ45 cable connector of the WAP-6200 to the
“P+DATA OUT” port of PoE Injector.
Note
Strongly suggest using SFTP cable, for better protection of the data
wire. 25-meter SFTP cable also available by order, the part no is
WL-SFTP-25. Please contact with local dealer for more information.
RJ45 CABLE
BACK COVER
FRONT COVER
CPE SET
POLE 1”-~1.5”
Mouting Kit
