2 Mega-Pixel Wireless Fish-Eye IP Camera
ICA-HM830W
Appendix A: Resetting Factory Default
Settings
There is a button hidden in the pinhole near the Mic. This button is used to restore all the factory
default settings. Sometimes restarting the Internet Camera will make the system back to a normal
state. However, if the system still got problems after restart, user can restore the factory default
settings and install it again.
Restoring the Internet Camera:
1. Unplug the power jack to turn off the power of ICA-HM830W.
2. Insert a pin into the reset hold as indicated in orange as shown in the figure below. Keep the
button pressed until instructed to release.
3. Plug in the power jack to turn on the ICA-HM830W. In about 20 seconds the LED indicator will
start to flash.
4. Release the button. (Remove the pin from the reset hold)
5. The ICA-HM830W can now return to factory default. Have access to the Internet Camera by
changing IP address from the default 192.168.0.20.
Restoring the factory default setting will lose all the previous settings including IP
address forever. User needs to run the PLANET IPInstaller program to search the
unit and configure it to let the Internet Camera work properly again.
65
