:ht=1:\
:ha=MFP_Server_ethernet_address:\
:ip=MFP_Server_ip_address:
Lines should be indented with tabs.
Where hostname is the device name of a MFP Server, the ht=1 tag specifies the
hardware type is Ethernet, the ha= tag specifies the Ethernet address of a MFP Server,
which is the Node ID located on the MFP Server. The ha tag must be preceded by the ht
tag. The ip= tag should correspond to the IP address you want to assign to the MFP
Server.
For example, a MFP Server with the following configuration:
Node ID: 00304F010101 (this implies Ethernet address is 00304F010101),
IP address: 203.66.191.12
The entry for this MFP Server in the /etc/bootptab file should be:
MF010101:\
:ht=1:\
:ha=00304F010101:\
:ip=203.66.191.12:
11.4
Verify MFP Server’s IP Address
To verify your MFP Server is responding to the newly assigned IP address using a PING
command:
ping ip-address
11.5
Configure Remote LPD Printing on the Host
78
The procedure you use to configure your Unix host(s) to allow printing to your network remote
MFP Server varies between different varieties of Unix. The procedure below can be used for
Unix variants that are related to BSD Unix, such as SunOS or Linux. For other versions of
Содержание FPS-1010MG
