Planet ADE-4400, Руководство пользователя

Страница: 33 / 65

The following table describes the parameters of this page:
Field Description
Default Route Selection You can select Auto or Specified .
VPI
The virtual path between two points in an ATM network,
ranging from 0 to 255.
VCI
The virtual channel between two points in an ATM
network, ranging from 32 to 65535 (1 to 31 are reserved
for known protocols)
Encapsulation You can choose LLC and VC-Mux .
Channel Mode
You can choose 1483 Bridged , 1483 MER , PPPoE ,
PPPoA , or 1483 Routed .
Enable NAPT
Select it to enable Network Address Port Translation
(NAPT) function. If you do not select it and you want to
access the Internet normally, you must add a route on the
uplink equipment. Otherwise, the access to the Internet
fails. Normally, it is enabled.
Enabel IGMP
You can enable or disable Internet Group Management
Protocol (IGMP) function.
PPP Settings
User Name
Enter the correct user name for PPP dial-up, which is
provided by your ISP.
Password
Enter the correct password for PPP dial-up, which is
provided by your ISP.
Type
You can choose Continuous , Connect on Demand , or
Manual .
Idle Time (min)
If set the type to Connect on Demand , you need to enter
the idle timeout time. Within the preset minutes, if the
router does not detect the flow of the user continuously,
the router automatically disconnects the PPPoE
connection.
WAN IP Settings
Type
You can choose Fixed IP or DHCP .

If select Fixed IP , you should enter the local IP
address, remote IP address and subnet mask.

If select DHCP , the router is a DHCP client, the WAN
IP address is assigned by the remote DHCP server.
Local IP Address
Enter the IP address of WAN interface provided by your
ISP.
Remote IP Address Enter the gateway IP address provided by your ISP.
Netmask Enter the subnet mask of the local IP address.
Unnumbered Select this checkbox to enable IP unnumbered function.
Add
After configuring the parameters of this page, click it to
add a new PVC into the
Current ATM VC Table .
Modify
Select a PVC in the Current ATM VC Table , and then
modify the parameters of this PVC. After finishing, click it
to apply the settings of this PVC.
Current ATM VC Table
This table shows the existed PVCs. It shows the interface
name, channel mode, VPI/VCI, encapsulation mode,
local IP address, remote IP address and other
information. The maximum item of this table is eight.
Click it, the PPP Interface-Modify appears. You can
modify the PVCs’ parameters.
Click in the PPPoE mode, the page shown in the following figure appears. In this page,
you can configure parameters of this PPPoE PVC.
33