3
INSTALLATION
Notes:
y
Choose the mounting location where the unit
will not interfere with the normal driving
function of the driver.
y
Before installing the unit, connect the wiring
temporarily and make sure it is all connected
up properly and the unit and the system work
properly.
y
Use only the parts included with the unit to
ensure proper installation. The use of
unauthorized parts can cause malfunctions.
y
Consult with your nearest dealer if
installation requires the drilling of holes or
other modifications of the vehicle.
y
Install the unit where it does not get in the
driver’s way and cannot injure the passenger
if there is a sudden stop, like an emergency
stop.
y
Avoid installing the unit where it would be
subject to high temperature, such as from
direct sunlight, hot air, from the heater, or
where it would be subject to dust, dirt or
excessive vibration.
DIN FRONT-MOUNT (Method A)
Installing the unit
(1) Metal Strap
Be sure to use the strap to secure the back of
the unit of the place. The strap can be bent by
hand to the desired angle.
(2) Mounting Bolt
(3) Hex Nut
(4) Spring Washer
(5) Tapping Screw
(6) Plain Washer
(a) Dashboard
(b) Holder
After inserting the holder into the dashboard,
select the appropriate tab according to the
thickness of the dashboard material and bend
them inwards to secure the holder in place.
Removing the unit
Insert both of the supplied keys into the slots at
the middle left and right sides of the unit, then pull
the unit out of the dashboard.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan, Toyota, follow these
mounting instructions.
Use the screw holes marked T (Toyota), N
(Nissan) located on both sides of the unit to
fasten the unit to the factory radio mounting
brackets supplied with your vehicle.
To fasten the unit to the factory radio mounting
brackets.
Align the screw holes on the bracket with the
screw holes on the unit, and then tighten the
screws (5x5mm) on each side.
Note: the outer trim ring, sleeve and the metal
strap are not used for method B installation.
Factory Radio
Mounting Bracket
Dashboard or Console
Side View showing
Screw Holes marked
T, N or S
Screw
Screw
a
b
Содержание P350UA
Страница 6: ...5 WIRING CONNECTION FOR 4X50W SYSTEM...
