Planar 2D-12, Руководство по установке

Страница: 4 / 36

4
2 Safety Instructions .
Do not install the fuel line inside the
cabin of a vehicle.
Do not install electric wiring (harnesses)
of the heater near the fuel line and the
exhaust pipe.
The vehicle where the heater is installed
must be equipped with a fire extinguisher.
Installation of the heater and its
component parts must be carried out by
specialized organizations approved by
the manufacturer. Installation of the
heater must be carried out only by
specialists in accordance with the
installation instructions.
Do not disconnect the heater from power
source until the end of the purge cycle.

When electric welding is carried out on the vehicle, or
repair work is made on the heater, the heater shall be
disconnected from the battery.

During installation and dismantling of the heater, the
safety rules specified by regulations for work on
electrical circuits and fuel systems of vehicles must be
observed.

The heater should not be connected to the electric circuit
of the vehicle with its engine running and no battery
installed.

Do not use fuses rated differently from indicated on the
electric circuit diagram.

Do not use makeshift devices (wires etc.) instead of
fuses.

The heater must be powered from the battery regardless
of the vehicle weight .

Do not connect and disconnect the heater connectors
when the heater power is on

Do not connect/disconnect electrical connectors of the
heater with power ON. After turning off the heater,
reconnection should be made at least after 5-10 seconds.