53
1. Start a programme as soon as you have filled the container (rapid
programme); otherwise the filter system, pump or other important
components of the appliance may be damaged. Failure to do so will
void the guarantee.
2. You must fill the container when the salt indicator has gone on. As
long as the salt has not dissolved, the indicator may stay on even the
container is full. If there are spills of the salt, a soak or rapid
programme should be run to remove excess salt.
Adjusting of the salt consumption
Step 1: Enter mode
Close the door within 60 seconds after you have switched on the appliance. Press
the Start/Pause button for 5 seconds. The appliance is in the salt-setting-mode
now. The indicators of the programmes indicate the current status of the salt
consumption, e.g. the "glass"-indicator
and
the "90min"-indicator correspond to
water hardness degree H6 (see schedule below).
Step 2: Setting of the salt consumption
Press the programme button to select a suitable setting corresponding to your local
requirements. The settings are consecutively numbered H1->H2->H3->H4->H5-
>H6.
Step 3: Exit mode
When you have not made an input for more than 5 seconds, the appliances changes
into the stand-by mode.
❖
There are 6 levels of salt consumption. We recommend to set the level relevant
to the schedule below.
❖
You can receive all relevant information about the local water harness range
from your water supplier.
Water hardness range*
Setting on
water softener
Display state
0
dH
Mmol/l
0-5
0-0.9
1
H1 (Rapid)
6-11
1.0-2.0
2
H2 (90 min)
12-17
2.1-3.0
3
H3 (90min/Rapid)
18-22
3.1-4.0
4**
H4 (Glass)
23-34
4.1-6.1
5
H5 (Glass/Rapid)
35-45
6.2-8.0
6
H6 (Glass/90 min)
