CHLORINE OUTPUT INDICATOR
(FIG. 1, ITEM 6)
Your power supply is fitted with ten green indicator lights set in an arc shaped formation.
During operation of your chlorinator these lights will illuminate relevant to the degree at which
the chlorine controls have been adjusted. Working in conjunction with the chlorine controller
you can increase or decrease chlorine output to suit your pool’s requirements. As you increase
the output (by turning the control knob clockwise) the corresponding lights will illuminate
progressively to 100% (ten lights).
You have full control of chlorine production by adjusting the chlorine controller and illuminating
the number of lights to satisfy your chlorine demand. Each light represents 10% of capable
chlorine production up to its maximum output of 100% (ten lights).
STATUS INDICATOR LIGHTS
(FIG. 1, ITEMS 1, 2, 3, 4)
There are four (4) status indicator lights located on the front of your chlorinator. These advise
at a glance the status of the chlorinator power supply and, when illuminated they indicate and
advise about the situation that the chlorinator’s electronic monitoring system has detected. The
lights and their functions are listed below.
When illuminated this indicates that you have exceeded recommended salt levels. As long
as this is not causing your chlorinator to overload no further action or reduction of salt
concentration is required at this point. No further salt should be added if this light is illuminated.
STEADY – When illuminated in a STEADY continuous light your chlorine production has been
switched off by turning the chlorine controller anti clockwise and your chlorinator power supply
is now in a standby mode. Turn the chlorine controller clockwise to resume normal operation.
FLASHING – If the light is illuminated and FLASHING the monitoring system has detected low
salt levels and this will need to be adjusted for the chlorinator to operate at maximum capacity.
This light will also flash if the cell has reached a point where its output is below the normal
operating output. Please refer to the section detailing the addition of salt to your pool.
STEADY
Power on
FLASHING
No Water Flow
STEADY
Cell off
FLASHING
Salt low
SALT HIGHER
THAN NECESSARY
No action required
STEADY
Overload
FLASHING
Normal operation
RP10QTH
RP10TH
STEADY
Power on
FLASHING
No Water Flow
STEADY
Cell off
FLASHING
Salt low
SALT HIGHER
THAN NECESSARY
No action required
STEADY
Overload
FLASHING
Normal operation
STEADY
Power on
FLASHING
No Water Flow
STEADY
Cell off
FLASHING
Salt low
SALT HIGHER
THAN NECESSARY
No action required
STEADY
Overload
FLASHING
Normal operation
RP10QTH
RP10TH
STEADY
Power on
FLASHING
No Water Flow
STEADY
Cell off
FLASHING
Salt low
SALT HIGHER
THAN NECESSARY
No action required
STEADY
Overload
FLASHING
Normal operation