Pixelink PPC15-CX, Инструкция по эксплуатации

Страница: 50 / 140

PPCxx-CX Series Flat Panel PC
Page 50
3-9
).
Figure 3-9: PPC-CX HDD Retention Screws
Step 5:
Connect the SATA/IDE cable to the rear of HDD.
Step 6:
Install the HDD into the panel PC by aligning the retention screw holes in the
HDD brackets with the retention screw holes on the chassis. Insert the four
retention screws.
Step 7:
Replace the aluminum back cover to the chassis.
Step 8:
Replace the plastic back cover.
Step 0:
3.7 AT/ATX Mode Selection
AT and ATX power modes can both be used on the PPC series. The selection is made
through an AT/ATX switch on the aluminum chassis inside the plastic back cover (
Figure
3-10
). To select AT mode or ATX mode, follow the steps below.
Step 1:
Remove the plastic back cover. See
Section 3.5
above.
Step 2:
Locate the AT/ATX switch on the aluminum chassis (
Figure 3-10
).