FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Declaration of Conformity
：
PIXAPRO Photo Equipment Co,Ltd. hereby declares that the This
equipment are in compliance with the essential requirements and
other relevant provisions of EU Directive 2014/30/EU. They are allowed
to be used in all EU member states.
Maintenance
●
Shut down the device immediately should abnormal operation be
detected.
●
Avoid sudden impacts and the product should be dedusted regularly.
●
It is normal for the flash tube to be warm when in use. Avoid continuous
flashes if unnecessary.
●
Maintenance of the flash must be performed by our authorized mainte-
nance department which can provide original accessories.
●
This product, except consumables e.g. flash tube, is supported with a
one-year warranty.
●
Unauthorized service will void the warranty.
●
If the product had failures or was wetted, do not use it until it is repaired
by professionals.
●
Changes made to the specifications or designs may not be reflected in
this manual.
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference received, including interfer-
ence that may cause undesired operation.Any Changes or modifications
not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference
-
1
3 -
-
1
4 -
