1. Over-Temperature Protection
●
To avoid overheating and deteriorating the flash head, the inner over-temperature protection function may be
activated and
will be displayed after firing more than 100 continuous flashes. If gets a slower recycle time in
firing, please allow a rest time of about 5 minutes, and the flash unit will then return to normal and the
will
disappear.
●
The inner over-temperature protection function may be activated when firing more than 200 continuous flashes in
fast succession at 1/1 full power and will be displayed. If gets a slower recycle time in firing, please allow a rest
time of about 5 minutes, and the flash unit will then return to normal and the will disappear.
Protection Function
Meaning
Prompts on LCD Panel
2. Other Protections
●
The system provides real-time protection to secure the device and your safety. The following lists prompts for
your reference:
Other Applications
Modeling Lamp
CITI1200 Pro
Kit is equipped with a 40W LED modeling lamp which has two continuous lighting modes:
Percentage and PROP.
• There are three modes: OFF, Percentage and PROP. Short press the Modeling Lamp Button, and the
three mode will be displayed on the LCD panel in sequence.
1. OFF:
the modeling lamp is off.
2. Percentage:
1%~100%.
3. PROP:
The modeling lamp's power changes with the flash's power. The bigger power the flash has, the
brighter the modeling lamp is.
• Long press the modeling lamp for 2 seconds to adjust the percentage of modeling lamp from 1%
to 100%.
Sync Triggering
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will be fired synchronously with the
camera shutter.
To control the flash wirelessly, you need to insert the receive end of flash trigger into the Wireless Control Port on
the flash and insert the transmit end into the camera hot shoe. Settings made on the hotshoe-mounted transmit and
receive ends will be wirelessly communicated to the flash. Then you can press the camera shutter release button to
trigger the flash. You can also hold the transmit end at hand to control your off-camera flash.
The Sync Cord Jack is a Φ3.5mm plug. Insert a trigger plug here and the flash will be fired synchronously with the
camera shutter.
Modeling Lamp
A failure occurs on the recycling system so that the flash cannot fire.Please restart the
flash unit. If the problem still exists, please send this product to a maintenance center.
E1
The voltage on two outlets of the flash tube is too high.
Please send this product to a maintenance center.
There are some errors occurred during the upgrading process.
Please using the correct firmware upgrade method.
E3
E9
CH
1
M
A
10
%
1/
256
+0.3
t.1
1/10100
● For full instructions on the use of flash trigger, see its user manual.
- 45 -
- 46 -
