Piusi CUBE B.SMART, Инструкция по установке, эксплуатации и обслуживанию

Страница: 45 / 60

45
/124
EN
45
/60
This manual belongs to PIUSI S.p.A. The reproduction of all or parts is prohibited.
CUBE
EN (translated from Italian)
20 MAINTENANCE
20.1 ROUTINE MAINTENANCE
CUBE B.SMART has been designed to minimize maintenance activities.
For maximum efficiency and safety of the station, however, the following
routine inspection and maintenance operations must be carried out
regularly.
Safety
information
The distribution system was designed and produced to require minimal
maintenance.
Before carrying out any kind of maintenance, the distribution system must
be disconnected from all sources of electrical and hydraulicsupply including
the battery.
During maintenance, using the personal protective equipment (PPE) is
mandatory.
In any case, bear the following minimum recommendations for efficient
system operation in mind.
Staff
authorised for
maintenance
operations
Maintenance operations must be performed solely by specialist staff. Any
tampering may impair the performance and endanger persons and/or
property, as well as invalidate the warranty.
IMPORTANT
Maintenance of electrical parts may only be carried out by qualified
electrical or electronic personnel.
Before performing any maintenance, make sure to disconnect the device
from the power line to switch it off and isolate it from the power mains.
If the device is sold without cable, periodically check the grounding circuit
in accordance with the regulations in force.
OPENING
AND CLOSING
OF CUBE
B.SMART
- Lower the display cover
- Loosen the 2 screws on the right side (indicated with the arrows)
- Open the inspection side of the CUBE B.SMART
- To close again, proceed in the opposite direction.
PUMP AND
PIPES
Check and keep the pump, the pipes and other internal station components
clean. Check that the flanged or threaded connections do not show leaks
and that the hoses are intact and not damaged (refer to the manual for
pumps and flow meters).