Page 3
For technical questions, please call 1‑800‑444‑3353.
SKU 93980
2. Loosen the Separator Jaw Nuts
(3) sufficiently to allow the jaws to
catch behind the bearing housing.
3. Using a wrench (not included),
begin to evenly tighten the Nuts
until the jaws are securely set
behind the bearing housing.
4. Screw in both Extension Screws
of the same length (4 / 12 or 6 / 9)
into the Bearing Separator Jaws as
shown below.
NOTE:
Do not use Extension
Screws of different lengths.
5. Place the 6 inch Yoke (16)
over the Extension Screws
and tightly secure with
Washers (7) and Nuts (3).
6. Screw in Lead Screw (5) into
the Yoke until it touches the
center of the shaft where the
bearings are mounted.
7. Using a wrench, turn the
Lead Screw clockwise until
the bearing housing begins
to move off the shaft.
8. Continue turning the Lead
Screw until the bearing
housing is off the shaft.
9. Remove the Lead Screw by
turning it counterclockwise.
10. Remove bearing housing
.
Shaft
Lead Screw (5)
Yoke (16)
Nut (3)
Washer (7)
Extension Screws
(4/12 or 6/9)
Nut (3)
Bearing
Separator Jaw
(2 or 14)
