Page 6
For technical questions, please call 1-888-866-5797.
Item 63984
Maintenance and Servicing
1. Before each use, inspect general
condition of Grease Gun. Check for
cracked or damaged parts, misaligned
or binding of moving parts, leaking
connections, and any other condition
that may affect product’s safe
operation. If a problem occurs, have
the problem corrected before further
use.
Do not use damaged equipment.
2. After every use, dry with a soft cloth,
remove all grease and debris from
Grease Gun. Do not use solvents to
clean or immerse in any liquids.
3. When storing, keep in a clean, dry and
safe location away from children.
4.
CAUTION!
All maintenance, service,
and repairs not discussed in manual
should only be performed by qualified
service technician.
PLEASE READ THE FOLLOWING CAREFULLY
NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED
TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED
TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF
HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
Troubleshooting
Problem
Possible Causes
Likely Solutions
Grease gun does not
dispense grease.
1. Trapped air in
grease.
2. Cold grease.
3. Grease gun
extension blocked.
4. Plunger rod did
not enter the
grease cartridge.
1. Loosen gun head. Move plunger
rod in & out to remove air
pockets. Tighten gun head.
2. Warm the gun.
3. Remove and clean gun extension.
4. Maneuver plunger rod to properly
go inside the cartridge.
Grease leaks from
the back of gun.
Thin grease.
Use a thicker grease.
Lever or grip handle
cannot be operated.
Gun piston damaged. Replace gun.
Grease coupler is stuck
on the grease fitting.
Grease fitting
does not match.
Tilt the coupler, twist & then pull back.
