7
GCP2100X-001_v01
Appliance structure
1
Juicer power base
a
Clutch
b
Accessories compartment
c
Accessories compartment lid
d
Power cord
2
Bowl
e
Spout
3
Strainer
f
Strainer handle
4
Juicing component (small and large cone)
5
Cover
The juicing component consists of two parts
(a small and large cone). The large cone can
only be used by placing it over the small one.
Preparing the juicer for operation
(disassembly)
Before the first use, disassemble the juicer and
wash all the parts having contact with the pro
-
cessed product.
1
Place the juicer near a mains socket on a hard, clean
and dry surface.
2
Remove the cover
(5)
and take out the bowl
(2)
with the
strainer
(3)
.
3
Disconnect the above-mentioned elements.
4
Remove the cone storage compartment cover
(c)
and
take out the juicing component
(4)
.
5
Take the juicing component
(4)
apart.
●
Wash the disassembled parts (except from the power
base and cone storage compartment cover) thoroughly
in warm water with an addition of washing-up liquid. After
drying them completely, start to assemble the cleaned
elements.
Do not wash the disassembled parts in dish
-
washers. For washing, use water at the tem
-
perature not exceeding max. 60°C.
Preparing the juicer for operation
(assembly)
1
Insert the bowl
(2)
into the power base
(1)
so that the
bowl spout (e) will fit in the middle of the slot of the power
base
(1)
and the four recesses in the bottom of the bowl
(2)
will fit into the four protrusions on the top surface of the
power base
(1)
.
2
Insert the strainer
(3)
so that the strainer handle
(f)
will
properly fit onto the bowl
(2)
.
A
B
C
SUGGESTION
Information on the product and
suggestions for its use
●
The appliance is intended for domestic use. In case of
using it for commercial purposes the warranty condi
-
tions will change.
●
Unplug the appliance after you finish using it.
●
Do not use abrasive cleaning agents in the form of
emulsions, creams, pastes, etc. for cleaning the appli
-
ance housing. They may remove graphical symbols,
such as scales, markings, warning signs, etc.
CAUTION!
Not observance can result in
damage to possessions
●
Do not carry the appliance while in use.
●
Do not disconnect the plug from the socket by pulling
the power cord.
●
Do not disconnect the plug from the socket when the
appliance is in use.
●
Connect the appliance to the mains socket (alternating
current only) with the voltage conforming to that given
on the rating plate of the appliance.
●
Do not expose the appliance to temperatures above
60°C.
●
Do not place the appliance on a wet surface.
●
Do not immerse the appliance power base in water
and do not wash it under running water.
●
Always place the appliance on a stable, even and flat
surface; the power cord may not hang over the edge of
the surface on which the appliance is placed.
Technical data
The technical parameters are given on the rating plate of the
product.
Maximum time of non-stop operation: 15 seconds.
An interval between repeated operation: 35 minutes (after
10 cycles).
Noise level (L
WA
): 68 dB(A).
The GCP2100X-type citrus press is built in insulation
class II.
The appliance does not need to be connected to an earthed
mains socket.
The GCP2100X-type citrus press meets the requirements of
relevant standards.
The appliance meets the requirements of the following direc
-
tives:
–
Low Voltage Directive (LVD) – 2006/95/EC.
–
Electromagnetic Compatibility (EMC) – 2004/108/EC.
The product is marked with CE symbol on the rating plate.
