WARNING
This appliance is equipped with a three prong
(grounding) plug. This is for your protection against
shock hazard in the event of equipment malfunction.
Always plug the unit directly into a properly grounded
three-prong receptacle. DO NOT cut or remove the
grounding (third) prong.
WARNING
DO NOT use an open flame to check for gas leaks!
Keep all open flames away from the Rethermalizer
until the installation is complete.
WARNING
A Rethermalizer equipped with casters and a flexible
power cord, must be connected to the gas supply with
a Quick-Disconnect device. This quick disconnect
must comply with ANSI Z24.41. To limit the
movement of the unit without depending on the
connector or quick disconnect, a re straining cable
must also be installed.
WARNING
There is an open gas flame inside the Rethermalizer.
The unit may get hot enough to set nearby materials
on fire. Keep the area around the unit free from
combustibles.
WARNING
Ensure that the Rethermalizer can get enough air to
keep the flame burning correctly. If the flame is
starved for air it can give off a dangerous carbon
monoxide gas. Carbon Monoxide is a clear odor-less
gas that can cause suffocation.
WARNING
Carbon monoxide can build up if you block the flue.
Blocking the flue will also cause the unit to overheat.
DO NOT obstruct the flow of combustion/ventilation
or air opening around the Rethermalizer. Ensure that
you meet the minimum clearances specified in the
installation instructions. Adequate clearance around
the unit is necessary for servicing and proper burner
operation.
WARNING
Wait 5 minutes before attempting to relight the pilot.
This will allow for any gas in the unit to dissipate.
WARNING
The power supply must be disconnected before
servicing or cleaning the appliance.
WARNING
The Rethermalizer must be properly restrained to
prevent movement or tipping. This restraint must
prevent the unit from movements that would splash hot
liquids on personnel. This restraint may be by any
means (alcove installation, adequate ties, or battery
installation).
WARNING
DO NOT obstruct the flow of combustion/ventilation
or air openings around the rethermalizer. Adequate
clearance around the rethermalizer is necessary for
servicing and proper burner operation. Ensure that you
meet the minimum clearances specified in the
installation instructions.
WARNING
NEVER supply the Rethermalizer with a gas that is not
indicated on the data plate. Using the incorrect gas type
will cause improper operation. If you need to convert
the unit to another type of fuel, contact your dealer.
WARNING
In the event of a fire, use ONLY a dry chemical
extinguisher. The extinguisher should be a B/C or
A/B/C type extinguisher that contains sodium
bicarbonate or potassium bicarbonate.
THIS MANUAL MUST BE
RETAINED FOR FUTURE
REFERENCE