ENGLISH
14
regulator housing.
3. Push the igniter button in repeatedlly until the burner is lit. Listen for the click
indicating spark ignition, and look to make sure the burner is lit.
If the burner goes out during operation, turn regulator knob to the "Off" position.
Open hood and wait five minutes before attempting to relight the grill to allow any
accumulated gas to dissipate.
If burner fails to light after three to four attempts, turn regulator knob to the "Off"
position and allow any accumulated gas to dissipate. Check for igniter spark by
pushing igniter button and looking at the igniter tip. If no spark, adjust gap between
electrode tip and burner to 3/16" (Fig. 3). If still no spark, see
Troubleshooting
Section.
Wait five minutes; then repeat the lighting procedures.
The burner can also be lit manually, see
Manual Lighting of the Grill
on the next
page.
Should you notice that your burner is getting hard to light or the flame is not as
hot as it once was, refer to the
"How to Clean your Burner"
section to remove any
possible obstructions.
