5
EN
ENGLISH
ASSEMBLY INSTRUCTIONS
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws completely
until all screws for that step have been installed. Hardware combination involving a locking washer and washer should be
installed with the locking washer closest to the head of the screw.
1. SECURING FEET TO SUPPORT LEGS
Parts Required:
1 x Left Front Leg
(#9)
1 x Left Back Leg
(#10)
1 x Left Front Leg Trim Piece
(#13)
1 x Left Back Leg Trim Piece
(#14)
6 x Screw
(#D)
Installation:
• Use three screws to attach the Left Front Leg Trim Piece to the Left Front
Leg for locking caster wheel. Continue to install the Left Back Leg for locking
caster wheel and Left Back Leg Trim Piece.
2. SECURING SUPPORT PLATES AND CASTER WHEELS
Parts Required:
1 x Left Front Leg
(#9)
1 x Left Back Leg
(#10)
1 x Left Bottom Support Plate
(#18)
1 x Short Support Plate
(#19)
2 x Swivel Caster with Brake
(#15)
8 x Screw
(#D)
Installation:
• Install one Short Support Plate to the side of the unit between of a Front and
Back Support Legs using four screws. Repeat the same installation to mount
the Bottom Support Plate to the same legs.
• Insert each Locking Caster Wheel into the Bottom of each Support Leg by
hand-tightening into the hole. Ensure the Locking Caster Wheel is inserted
completely by ensuring it cannot rotate any further.
NOTE: Make sure Bottom Support Plate is facing up with correct direction.
ASSEMBLY PREPARATION
Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact Bunnings Australia or Genesis International Corporation
Pty Ltd. for Customer Service.
[email protected] | +61 8 9248 9822
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly:
screwdriver and level.
Tools not included.
1
9
10
13
14
2
19
9
10
18
15
15
Содержание Navigator 850
Страница 11: ...11...
