10
EN
ENGLISH
15. INSTALLING THE GRILL COOKING COMPONENTS
Parts Required:
1 x Cooking Grid A
(#27)
2 x Cooking Grid B
(#28)
1 x Porcelain-Coated Steel Upper Warming Rack
(#29)
Installation:
• Place the Cooking Grids, side by side, on the grid ledge inside the Main Grill.
• Place the Upper Cooking Rack on the upper ledge inside the Main Grill.
The Warming Rack will lock into place.
16. INSTALLING THE GREASE BUCKET
Parts Required:
1 x Grease Bucket
(#25)
Installation:
• Place the Grease Bucket on the spout hook on the end of the Main Barrel.
Ensure it is level to avoid grease spills.
• The unit is now completely assembled.
17. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss
®
into any electrical outlet, ensure
the temperature dial is in the OFF position.
•
STANDARD OUTLET
This appliance requires 220-240 volts, 50hz, 250w service. It must be a
3-prong grounded plug.
•
GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity, which
can be too much power for a GFCI outlet to handle. Each time it trips, it
increases in sensitivity. If the GFCI keeps tripping, replace the outlet or
change to a non-GFCI outlet.
•
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss
®
unit can operate using a 12 volt, 100 watt
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
IMPORTANT: Refer to Owner's Manual for Operating Instructions
17
FAST-BLOW FUSE,
5 AMP
16
25
15
28
28
29
27
Содержание Navigator 850
Страница 11: ...11...