ENGLISH
11
9. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss
®
into any electrical outlet, ensure
the temperature dial is in the OFF position.
•
STANDARD OUTLET
This appliance requires 110-120 Volt, 60 Hz, 250 W. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from the
igniter.
•
GFCI OUTLETS
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity, which
can be too much power for a GFCI outlet to handle. Each time it trips, it
increases in sensitivity. If the GFCI keeps tripping, replace the outlet or
change to a non-GFCI outlet.
•
ON THE ROAD
Disconnect the igniter from the main wiring harness. Use the manual
start-up procedure. A Pit Boss
®
unit can operate using a 12 volt, 100 watt
inverter plugged into your automobile outlet. To use the automatic
igniter, it is recommended to use a minimum of a 1000 watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
8. PLACING THE GREASE CUP
Parts Required:
1 x Grease Cup (#7)
Installation:
• Press down and while holding the release button, slide the Grease
Cup into the grease cup brackets on the underside of the Grill Body.
Release the button to lock the Grease Cup into position. The unit is
now completely assembled.
9
FAST-BLOW FUSE,
5 AMP
8
7