ENGLISH
7
2. MOUNTING THE LEGS TO THE MAIN BARREL
Parts Required:
1 x Main Barrel /Hopper Assembly (#10)
1 x Support Leg for Wheel / Front (#16)
1 x Support Leg for Wheel / Back (#17)
6 x Screw (#A)
6 x Washer (#B)
6 x Locking Washer (#C)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit and
parts during assembly. Lay the Main Barrel on its side on the cardboard,
hopper end pointed upward.
• Mount one Support Leg with Wheel to the floor end of the Main Barrel
using three screws, locking washers, and washers, through the three
pre-drilled holes. Install screws from the inside of the Main Barrel.
Repeat installation for second Support Leg with Wheel.
3. INSTALLING THE BOTTOM SHELF
Parts Required:
1 x Bottom Shelf (#19)
1 x Support Leg / Front (#14)
1 x Support Leg / Back (#15)
10 x Screw (#A)
10 x Washer (#B)
10 x Locking Washer (#C)
Installation:
• Mount the Bottom Shelf to each Support Leg using a screw, locking
washer, and washer. Ensure the flat surface of the shelf is facing up
towards the Grill Barrel. Note 3A.
• Mount on Support Leg to the hopper end of the Main Barrel using three
screws, locking washers, and washers, through the three pre-drilled
holes. Install screws from inside of the Main Barrel. Repeat installation
for second Support Leg. Note 3B.
• Connect the Bottom Shelf to both Support Legs with the final two
screws, locking washers, and washers. Note 3C. Once the shelf is
secure, carefully lift the grill into an upright position.
10
17
16
A
C
B
2
比例 1.
000
19
比例 1.000
C
A
B
B
A
C
B
A
C
3A
3B
3C
14
15
19
