Emergency
Zone
Highlight it press Enter, Default is NO, (
If you set YES, the zone will be on 24hours,
regardless of your system’s Arm or Disarm status. This is recommended to be used for smoke detector, panic button,
water leak sensor and temperature sensors only. DONOT set any door sensor or motion sensor as Emergency zone
).
Home Zone
Highlight it press Enter, Default is YES, (
if you select NO, the zone will disable during home alarm
status, recommended for motion sensor NO, and all Window/door sensor YES
)
Chime
Zone
Highlight it press Enter, Default is NO,( does
not work with motion sensor.
)
Delayed Zone
Highlight it press Enter, Default is NO, (
if set YES, allows you to come back home and open the
door without triggering the system. System default delay alarm time is 45 seconds. You can change this time by going
to "System Settings" and set the Alarm Delay time
).
Siren Enable
Highlight it press Enter, Default is YES, (
if set NO, siren will disable when this zone triggered, no
siren alarm will sound.
)
Note:
All zones are instant zones by Default
.(“
Instant “refers to the system being immediately armed if any zone
is triggered when the system is in armed status
.)
Delete
select it then press Enter, you can
find the target sensor and delete it, you
can delete any sensor from
panel.
Test the Motion Sensor
The Motion Sensor will initialize itself during the first 1-3 minutes after the front cover is re-
attached
（
DO NOT KEEP Cover open
）
. Do not test it during initialization. You can walk 3-5
steps in front of motion sensors after initialization, the LED will remain on for 3 seconds when
motion is detected until the Motion Sensor short blinks once again before resuming motion
detection for next detector.
1. Move away from the area that is in direct line of sight of the Motion Sensor (move to an adjacent
room). Wait 60 seconds until the LED stops blinking.
2. Move back into the line of sight of the Motion Sensor, walk around 3-5 steps. (this will trigger the
main console).
If the Motion Sensor
test is successful the
LCD screen will
display " xxx Sensor
Alarm". If these words
do not appear, either
(A) the 20-second
waiting period since
the last trigger has not
expired, or (B) the Motion Sensor is not in communication with the PiSECTOR system
main console.
If you want to re-start the Walk Test mode again, open the Front Cover as shown in
Figure 1 and then re-attach the Front Cover.
Note1:
For saving battery power, motion sensor may be insensitive if you active it more than
three times in a few minutes. Please leave the detectable area for a few minutes and come back,
it will detect you again.
Note2:
Motion sensor may be insensitive or give a lot false alarms if the temperature is more
than 98F (37C).
