Outdoor Wireless Siren
If you received a pre-Programed system kit, please ignore
this step and do not program it again
Press
PROGRAM
key on the console. Enter default password
888 888
. Use the
scroll key
to select Wireless Sirens, press
ENTER
. You will see below list.
Add
for add a wireless sensor, highlight
Add
press
Enter
, you will see a default siren
name such as Siren1 / Siren2 / Siren3, then press Enter You will see"
Put siren in Setting Mode
". You will
see "
Put siren in Setting Mode
" Siren1 / Siren2 / Siren3.
Plug siren into the
power adapter
(
9V 500mah
), and you will hear ONE beep. Unplug and plug the siren a
second time within seconds after the first time, you will hear ONE beep again. Unplug and plug the siren the
third time within seconds after the second time, you will hear a FEW short beeps from the siren. The FEW
short beeps mean the siren is ready and in setting mode for program. Go back to the main console and
press Enter immediately (
no more than 5 seconds after the few short beeps
), you will hear 3 beeps, 2 short
beeps, and 3 beeps consecutively for conformation. That means your siren has been added to your main
console. You may press
“back” key until the console displays “System Disarmed”
and the date /time page.
Unplug siren from the power adapter and wait for 10 seconds to exit the setting mode.
Test
: Connect siren
to the power adapter. Press Emergency key on the main console. You should hear the alarm sounding.(
If
you plug the siren to the adapter, and unplug, plug consecutively and rapidly for 5 times, the siren will be
deleted from the main console. You may need to follow the steps above to re-program
)
Edit
If you select Edit then press Enter
, select the siren’s name and press Enter. You will then be able to change the
siren’s name.
Delete
If you find system shows
“Space full” while you add extra siren or reprogram siren, select "Delete". Delete all
"Siren 1”"Siren 2 “"Siren 3”names, then you are able to re-program your siren by upon instructions (
you can
’t
delete the siren, this only deletes the sirens name. if you want to delete siren from your system, you need
delete it on Siren, detail see how to delete your siren on siren manual page or FAQ
.)
Siren Enable
select "Siren Enable". If you set No, the sirens will not give any alert for the entire system. If you only
want to set an individual zone's siren, you have to go to each zone and Edit. For details, read Edit Sensor
Functions
Duration
You can set wireless sirens to sound on a continuous alert. You can set it from 1 second to a maximum of
180 seconds.
Arm/DisarmTone
select Arm/Disarm Tone and press Enter,If you set Yes, when you use the remote control to arm
and disarm system, you will hear a loud beep warning from the siren. You can set
No
to turn off this warning
tone if you don’t like it. Default is No.
Encrypt
select Encrypt then press Enter, you will see default 1234 and blink, you can direct input another 4 digits to
encrypt your siren
.
BEWARE
If you change encryption code to a new code, you need to re-program all of
your wireless sirens to the console again, you may change it before you program your sirens. Once you
change it, DO NOT change it when you are going to add a second or third siren, otherwise you will lose the
first siren’s program.
https://www.youtube.com/watch?v=BQEkK__q3Ug&feature=youtu.be
