No Diving or Jumping. Observe all Safety Rules
Section
4
GENERAL INSTRUCTIONS -
ROUND POOLS
ASSEMBLING THE POOL FRAME
1. Continue filling your Pool
a. Continue filling your pool with water. Do not put in more
than 12” (30 cm) of water until the top ledges and upright
columns are all attached.
b. Keep working on the top ledges and uprights while the
pool fills.
See the drawing on the next page for an overview of
all the parts used to install the uprights, top ledges
and top connectors.
2. Install the uprights.
a. Line up the bottom of one upright (key 1) with the two
small tabs on one base plate (key 2). The tabs must be
on the inside of the upright. The three holes on the front
of the upright must be nearest the top.
b. Line up the screw holes and fasten with one self-tapping
screw on each side (key 3).
(Image 1)
c. Hook a top plate (key 4) over the top edge of the pool
wall (key 5). Place the top plate down over
the top of the upright with the tabs on
the outside of the column. Make sure the upright is
straight up and down.
d. Line up the screw holes and fasten with one self-tapping
screw on each side and one on the front (key 6).
e. Repeat the last four steps for each of the upright around
the pool wall.
A. INSTALLING THE TOP LEDGES AND UPRIGHTS
1
Important Note:
Use the ridges in the pool wall to make sure the upright is
straight up and down.
4-1
1
3
2
5
6
4
2
Содержание V35046
Страница 1: ...INSTALLATION MANUAL ROUND POOLS Esprit II Evolution SouthportGlx Pretium POOL MODEL V35046 12 15 ...
Страница 2: ......
Страница 4: ......
Страница 36: ...No Diving or Jumping Observe all Safety Rules ...