15
4.7.2.2
Inline brake sensors work by detecting the movement
of the brake cable which is threaded through the
sensor. They are compatible with all brake types that
have a protruding brake cable.
Note: The inline sensors are NOT compatible with
Hydraulic brakes.
1.
To install, thread the brake cable through the hole in the centre of the sensor and
install at the base of the brake lever housing.
2.
The arrow on the sensor should point towards the brake lever.
3.
When the brake cable is pulled the movement is detected and will cut off the
motor power instantly.
Note: The sensor can be installed anywhere along an exposed section of the brake cable
wherever there is a join between the wire cable and the protective plastic sheath.
Install the Throttle
The standard conversion kit includes a
universal thumb throttle as shown here.
The most common setup for the throttle is to place it on
the left hand side of the handlebar, however this
depends on rider preference, and this universal device
can be used on either side.
To install the thumb throttle, you will need to remove
any existing hand grips and other components first.
Other types of throttle are available for purchase as shown below. These include full twist,
half twist and swing throttles.
To purchase any of these throttles you must first determine whether you prefer the
throttle on the left or right.
