Piranha P65, Руководство пользователя

Страница: 18 / 53

Operating Instructions 18
Stripper Assembly Adjustment
NOTE : The selector switch should be in the "OFF" position until all tooling changes are
complete. Reference page 13 , figure B.
The adjustment of the stripper assembly to compensate for varying punch lengths should
be accomplished in the following manner. (Reference page
37 for a visual reference).
NOTE : The correct adjustment should have the tip of the punch 1/16
” below the bottom
of the stripper footplate and the stripper footplate level.
1. Install the stripper assembly on the upper beam (reference instructions
previously listed).
2. Insert punch in the stripper assembly (reference instructions previously listed).
3. Measure the length of the punch relative to the bottom of the stripper foot.
4. If the tip of the punch extends more than 1/16" below the bottom of the stripper
foot, adjustment is required.
5. Turn the two (2) guide pin adjusting caps counterclockwise until the tip of the
punch extends 1/16
” below the bottom of the stripper footplate. The stripper
footplate MUST remain level or parallel to the work material. The punch tip
should be able to line up on a center punch mark before the stripper footplate
engages the material.
6. If the tip of the punch does not extend 1/16
” below the bottom of the stripper foot,
or if the stripper footplate is not parallel with the work material, adjustment is
required.
7. Turn the two (2) guide pin adjusting caps clockwise until the tip of the punch
extends 1/16" below the bottom of the stripper footplate. The stripper footplate
MUST remain level or parallel to the work material. The punch tip should be able
to line up on a center punch mark before the stripper footplate engages the
material.