Pioneer XV-DV180, Руководство по обслуживанию

Страница: 41 / 101

41
XV-DV282AP
5 6 7 8
5 6 7 8
A
B
C
D
E
F
Removal of DVD MECHA Assy Parts
Fig. 1-A
Tray
Push to Sag
Push to Sag
LOADER Assy
Fig. 2-A
Tray
LOADER Assy
Fig. 1-B
Insulator (R)
TRAVERSE Assy
LOADER SUB Assy
Fig. 2-B Check Lock
TRAVERSE Assy
Rack Loading
LOADER Assy (Bottom Side)
Holder Traverse
Fig. 2-C
LOADER Assy
Check Hook
Loading Belt
LOADING SUB Assy
Gear Pulley
Fig. 3-A
LOADING MOTOR PCB Assy
• Screw Torque: 2.0
±
0.3 kgf•cm
• Screw Torque: 2.5
±
0.3 kgf•cm (Screw
1
)
• Screw Torque: 1.0
±
0.3 kgf•cm (Screw
2
)
Loading Motor
NOTE
Disassemble only the DVD MECHA Assy parts listed here.
Minute adjustments are needed if the disassembly is done.
If the repair is needed except listed parts, replace the DVD
MECHA Assy.
1: TRAY (Refer to Fig. 1-A)
1. Set the Tray opened. (Refer to the DISC REMOVAL
METHOD AT NO POWER SUPPLY )
2. Unlock the 2 supports
1
and draw it while sagging the
Tray.
NOTE
1. In case of the TRAVERSE Assy, install it from (1) to (4)
in
order. (Refer to Fig. 2-B)
2. In case of the TRAVERSE Assy installation, hook the
wire on the LOADER Assy as shown Fig. 2-C.
3: LOADING MOTOR PCB Assy / LOADING BELT
(Refer to Fig. 3-A)
1. Remove the Loading Belt.
2. Remove the screw
1
.
3. Remove the LOADING MOTOR PCB Assy.
4. Remove the 2 screws
2
.
5. Remove the Loading Motor.
6. Remove the Gear Pulley.
NOTE
1. In case of the Tray installation, install them as the circled
section of Fig. 1-B so that the each markers are met.
2: TRAVERSE ASSY (Refer to Fig. 2-A)
1. Remove the screw
1
.
2. Unlock the 2 supports
2
.
3. Remove the Insulator (R) from the LOADER SUB Assy.
4. Remove the TRAVERSE Assy.
1
1
2
2
1
2
2