Pioneer XV-DV180, Руководство по обслуживанию

Страница: 43 / 101

43
XV-DV282AP
5 6 7 8
5 6 7 8
A
B
C
D
E
F
NOTE
1. In case of the Clamper Assy installation, install correctly
as Fig. 5-B.
NOTE
1. In case of the Insulator (F) installation, install correctly
as Fig. 6-B.
6: HOLDER TRAVERSE/INSULATOR (F)/INSULATOR (R)
(Refer to Fig. 6-A)
1. Remove the Holder Traverse.
2. Remove the 2 Insulator (F).
3. Remove the Insulator (R).
7: SW PCB ASSY/GEAR MIDDLE/GEAR FEED/
RACK FEED ASSY/FEED MOTOR
(Refer to Fig. 7-A)
1. Unlock the support
1
.
2. Remove the Gear Middle.
3. Remove the screw
2
.
4. Remove the Rack Feed Assy.
5. Remove the screw
3
.
6. Remove the SW PCB Assy.
7. Remove the screw
4
.
8. Remove the Gear Feed.
9. Remove the 2 screws
5
.
10. Remove the Feed Motor.
11. Remove the Gear Motor.
NOTE
1. When installing the Rack Feed Assy, push both ends to
align the teeth as shown Fig. 7-B. Then install it.
2. In case of the Gear Motor installation, check if the value
of the Fig. 7-C is correct.
3. When installing the wire of the SW PCB Assy, install it
correctly as Fig. 7-D.
Manual soldering conditions
• Soldering temperature: 320
±
20 °C
• Soldering time: Within 3 seconds
• Soldering combination: Sn - 3.0 Ag - 0.5 Cu
4. After the assembly of the TRAVERSE Assy, hook the
wire on the TRAVERSE Assy as shown Fig. 7-E.
1
5
5
4
2
3
Holder Traverse
Insulator (F)
TRAVERSE Assy
Insulator (F)
Insulator (R)
Fig. 5-B
Plate Clamper
Clamper
Fig. 6-A
Fig. 6-B
Traverse Holder
Insulator (F)
Gear Middle
Gear Motor
Feed Motor
• Screw Torque: 1.3
±
0.3 kgf•cm (Screw
2
)
• Screw Torque: 3.0
±
0.3 kgf•cm (Screw
3
)
• Screw Torque: 1.0
±
0.3 kgf•cm (Screw
4
,
5
)
SW PCB Assy
Rack Feed Assy
Gear Feed
Fig. 7-A
TRAVERSE Assy
[OK] [NG]
Fig. 7-B
Rack Feed Assy
Push
Push
Fig. 7-C
8.0
±
0.2 mm
Safety surface for pressing
of the insert.
Feed Motor
Gear Motor
Check Lock
Pickup lens
GEM1004
GED-008