21
XDJ-R1
5
6
7
8
5
6
7
8
A
B
C
D
E
F
6. SERVICE MODE
6.1 SERVICE MODE
[1] Service mode
This unit supports the Service mode as follows:
1. Mode to check buttons and displays
• This is a mode which can check if buttons and displays are properly performed.
2. Mode to check LED
• This is the mode which can examine whether LED turns on.
• All LED turns on with this mode.
3. JOG dial load measurement mode
• Mode to measure the load when the JOG dial is rotated.
4. CD drive diagnostic mode
• Mode to check if the CD drive is properly performed.
5.
V
ersion checking mode (when multiple micro processors are used, this mode is supported.)
• Mode to check each micro processor's software version.
6. Error history display mode
• Mode to check error history (saved up to 16)
7. Displaying A/D values mode
• Mode to check A/D values, such as volume.
8
. Center settingfor the controls
• Mode to set the center value for the controls.
9. Factory reset
• Mode to reset the PLAYER's settings to factory default.
10. Firmware update
The above modes are applicable to both DECK 1 and 2 with a few exceptions.
[2] Detailed specifications of each mode
•
W
hen the unit is powered on while pressing both the TIME and TEMPO RA
N
GE button on DECK1 simultaneously,
this mode starts after [SER
V
ICE MODE] is displayed for 2 seconds on the dot display.
• You can check whether buttons, knobs and displays are performed properly in this mode.
• In the dot display, TIME display mode is always shown in the upper row and the button names excluding the I
N
FO/UTILITY
button light up in the lower row while they are pressed.
• TIME display mode starts from the DECK
V
OL display mode.
•
W
hen the TEMPO slider is moved far down to the [+] side during this mode, the mode is switched to JOG dial load
measurement
mode.
Dot display
Time display
: (1)
: (2)
: (3)
1. MODE to check buttons and displays