Pioneer VSX-AX5i-G, Руководство по эксплуатации

Страница: 20 / 120

Connecting Your Equipment
20
En
Connecting Analog Audio Components
Before making or changing the connections, switch off the power and disconnect the power cord from the AC
outlet.
Connect your audio components to the jacks as shown below. These are all analog connections and your
analog audio components (turntable, cassette deck) use these jacks. Remember that for components you
want to record with you need to hook up four plugs (a set of stereo ins and a set of stereo outs), but for
components that only play (like a turntable) you only need to hook up one set of stereo plugs (two plugs). If
you want to record to/from digital components (like a CD-R) to/from analog components you must hook up
your digital equipment with these analog connections.
*The arrows indicate the direction of the audio signal.
Memo:
• If you want to hook up any equipment other than a turntable to the PHONO/LINE jack please go to the
PHONO/LINE Setup (see page 95) and choose the LINE setting. If your turntable has a phono pre-amplifier
(most do not) please choose the LINE setting as well.
• Depending on where the cassette deck is placed, noise may occur during playback of your cassette deck
which is caused by leakage flux from the transformer in the receiver. If you experience noise, move the cas-
sette deck farther away from the receiver.
S400
S400
(AUDIO)
(Single)

Audio cords
Use (RCA) audio cords (not supplied) to
connect the audio components.
Connect red plugs to R
(right) and white plugs
to L (left).
Be sure to insert
completely.
If your turntable has a ground
wire, connect it to the signal
ground terminal (

).
CD player
Cassette deck
CD recorder
Turntable
VSX-AX5i.book Page 20 Friday, May 23, 2003 6:33 PM