Adjusting initialsettings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1
Function display
Shows the function names.
1 Touch the source icon and then touch
OFF to turn this unit off.
#
When the source icon is not displayed, you
can display it by touching the screen.
2 Touch A.MENU and then touch INITIAL
to display the function names.
The function names are displayed and oper-
able ones are highlighted.
#
When
A.MENU
is not displayed, you can dis-
play it by touching the screen.
#
You can also display
MENU
by clicking the
joystick.
#
To go to the next group of function names,
touch
NEXT
.
#
To return to the previous group of function
names, touch
PREV
.
#
When the multi-channel processor (e.g., DEQ-
P7650) is connected to this unit, you can operate
DIGITAL ATT
instead of
REAR SPEAKER
.
#
To return to the previous display, touch
BACK
.
#
To return to the display of each source, touch
ESC
.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Touch A.MENU and INITIAL and then
touch FM STEP.
2 Touch
c
or
d
to select the FM tuning
step.
Touching
c
or
d
will switch the FM tuning
step between 50 kHz and 100 kHz while AF or
TA is on. The selected FM tuning step will ap-
pear in the display.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Setting the AM tuning step
The AM tuning step can be switched between
9 kHz, the preset step, and 10 kHz. When
using the tuner in North, Central or South
America, reset the tuning step from 9 kHz (531
1,602 kHz allowable) to 10 kHz (530
1,640
kHz allowable).
1 Touch A.MENU and INITIAL and then
touch AM STEP.
2 Touch
c
or
d
to select the AM tuning
step.
Touching
c
or
d
will switch the AM tuning
step between 9 kHz and 10 kHz. The selected
AM tuning step will appear in the display.
InitialSettings
En
82
Section
16