5
En
3
ExtraPower
Frt. Movie
/
Frt. Music
After connecting the speaker wires to the surround
speakers, use the groove provided to secure the speaker
wire as shown at left. Leave 10cm of slack from the
speaker terminals so the upper (surround) speaker can
turn freely.
When you're finished, thread the surround speaker
cords through the outlet on the base of the speaker
stand as above.
Turn the surround speakers 50º towards
the closest wall.
The speaker will stop turning at about a 50º angle.
This is only necessary with the
Frt. Movie
or
Frt.
Music
modes (leave them facing forward with
ExtraPower
). See the operating instructions for more
on the Front Surround modes.
Caution
To prevent accidents when in use, make sure the
surround speaker is secure by turning it so the
arrow
at the base of the speaker is not in the
UNLOCK AREA
.
To keep the stand steady when upright, tuck the
speaker cords into the grooves on the bottom as
shown below.
1
2
Attach the non-slip pads to the base
of the center speaker.
Use the adhesive to attach 4 pads to the base of
center speaker.
Connect the speaker system.
This setup is ideal when rear surround speaker placement
isn’t possible or you want to avoid running long speaker
cables in your listening area.
Front surround
3-spot setup
Front
left
Front
right
Surround
left
Surround
right
Listening position
Center
Subwoofer
Refer to the setup guide provided to connect the
speakers properly. After connecting the front
speaker wires, thread the front speaker cords
through the outlet on the base of the speaker
stand as shown below. Make sure to use a
stable surface when doing this, and lay the
speakers flat on their side.
With the 3-spot setup, it is recommended that you fix
the surround speakers in place with the adhesive strips
provided when in use.
